128M的VPS装哪个面板占用内存小

dos最小了，就几兆

不过你应该不会考虑吧

其实你的问题应该是你的内存适合什么系统吧

1g一下，xp

1-2g，windows 7

2g以上windows 7或vista

4g或以上，64位的windows 7或vista

如果内存超过了1g不建议用xp，毕竟太老了，问题比较多，而且会越来越明显

补充：windows 7和vista 的内存占用和xp不同，是按照比例占用的，一般情况是占用50%左右（会预添加程序，提高程序打开速度，根据内存大小自动调整预添加的程序数量），xp则是比较固定的300m左右

可详谈771897027

At any requested input, hit return to accept the default response. Once the cd is fully booted, it is time to prepare it to preform the image restore to your disk space by entering the following commands.启动后一路回车，使用默认值启动。使用下列命令恢复CentOS到硬盘：/etc/init.d/rpc.statd restartmkdir /mnt/sysmount lanas.hostigation.com:/mnt/volgroup00/logvol00/kvm /mnt/sys *** or 或者 ***mount rhnas.hostigation.com:/mnt/exports/exports/kvm /mnt/sysdd_rescue /mnt/sys/CentOS-5.6-i386.img /dev/sda *** or 或者 ***dd_rescue /mnt/sys/CentOS-6.0-i386.img /dev/sdaWith the above, you have some choices to make, if your VPS is in Los Angeles, you will want to select the line with lanas.hostigation.com otherwise the line with rhnas.hostigation.com for Rock Hill SC. Also, depending which version of CentOS you wish to install will determine your other selection.执行命令时会出现一些选项，如果你的KVM在Los Angeles 就选择 lanas.hostigation.com，在Rock Hill SC就选择rhnas.hostigation.com。还有一些其它选项，相应的做出选择就行了。 Once the restore has finished, back in SolusVM insure your Hard Drive is set to boot first in the boot order and click reboot, these images are set to use DHCP to obtain your IP address and the default root password is set to t3mp4n0w! please change this as soon as logging in the first time.镜像恢复完毕后，到SolusVM控制面板将Hard Drive(硬盘)设置为第一启动顺序。然后重启，系统会自动获取IP地址，默认的root密码是t3mp4n0w。登录后请立即修改root密码！ One problem has been found that may effect your image, if after your first boot you have no networking, check dmesg and see if it renamed eth0 to eth1, if so如果出现没有网络连接的意外情况，可能是网卡被命名为eth1导致的，执行下面命令解决rm /etc/udev/rules.d/70-persisent-net-rules and reboot.然后执行reboot重启系统。

---